Tuesday December 1, 2009
Drilled F-7101 and F-902 (Forward Fuselage)
1.7 Hours

Previous - Index - Next

Here's my awesome new propane heater for the garage. It gets the shop toasty in about 10 minutes. Just have to leave the door cracked while it's running so I don't run out of oxygen!

I prepped the F-902 bulkhead halves by drilling open the rudder cable holes and riveting on a couple of nutplates. Then, I cleco'd the F-902 and F-7101 plate to the skin and drilled everything.

Same on the other side...this structure is really beefy.

Previous - Index - Next


Creative Commons License Unless otherwise stated, all content on this site is licensed under a Creative Commons Attribution-Noncommercial-No Derivative Works 3.0 Unported License.