Friday April 16, 2021
Forward Deck Angle Fab
(0.2 Hours Cabin Frame, 1.0 Hours Forward Deck)
1.2 Hours Total

Previous - Index - Next

I got the large AN426AD5 and AD6 rivets today for the over-sized hole in the roll bar. I went with the AD5, since it would secure the hole without needing to be oversized.

Then, since I'm still waiting on the 120 degree countersink bit to finish riveting the roll bar, I started working on fabricating some angles for the forward deck structure.

Previous - Index - Next


Creative Commons License Unless otherwise stated, all content on this site is licensed under a Creative Commons Attribution-Noncommercial-No Derivative Works 3.0 Unported License.