Monday September 6, 2021
HS Tip Ribs (Horizontal Stabilizer)
1.0 Hours

First, I took a look again at the elevator tips. There are some imperfections here that I will sand once the primer has cured for 3 days, but it doesn't look too bad.

The left side is a little worse and will need more priming/filling.

Then, I cut these little ribs out of balsa and glued them in place with epoxy/flox mixture.

The other side...

Once these cure, I'll take the tips off and lay up some fiberglass inside over the balsa to give them real strength.

This work is licensed under Attribution-NonCommercial-NoDerivatives 4.0 International