Monday July 8, 2024
Oil Cooler Diffuser Layup (Firewall Forward)
2.0 Hours

Today I started by spraying my mold with release spray. And then I laid up 3 layers of fiberglass over it followed by peal ply. It was tricky cutting pieces that would lie flat on the various curves, but I think it worked in the end.

Tomorrow I'll remove the peal ply and then try to get the mold out of the piece. I will have to destroy the mold...there's no other way to get it out.

This work is licensed under Attribution-NonCommercial-NoDerivatives 4.0 International